E-mail: info@fdsp-cn.com
Tel: +86-025-66621288-108

Saving energy complete wood pellet line

Complete wood pellet line can process various kinds of woody biomass such as round wood, wood chips, wood branches, wood shavings, wood barks and sawdust etc. Wood pellets made by FDSP complete wood pellet line are with high density and high heat value, low ash content and low moisture content, and smooth surface. 

Finished Products:


complete wood pellet production line

Suitable Raw Material

wood, sawdust, sugar cane, bamboo, rice husk, grass, straw, etc, and 

some special raw materials like rubber, clay and plastic as well..

After-sale guarantee

One year warranty and all around after-sale service.

Technical Parameters 

- Capacity: 0.5t/h-30t/h or even more

- Dimensions: Designed according to specific requirements

-Power consumption: would be listed in the quotation, actual consumption

is 20-30% lower than theory.


- Top technology with national patent

- Customized design and reasonable price.

- Non-dust workshop with experienced engineers.

- Main machines adopt Siemens motor and imported SKF/NSK bearing.

- PLC control(Siemens) and Schneider or Soft Starter electric control system.

- Long service time and stable operation.

- Guide installation and commissioning is available.

Packing Details

 Iron case or iron pallet etc


 1 Set


 L/C, T/T, Western Union, Money Gram as client require


 1 year

complete wood pellet line process:

(a)Peeling Process 

Wood debarker machine is applicable to peel the log of MDF board and papermaking industry, it is mainly used to peel log, small wood and so on, the peeled rate is more than 95 percent.


(b)Chipping Process

 In the pellet plant before raw materials are made into biomass pellets, they are 

first reduced into much smaller, uniformly-sized particles. When the thicknedd is larger than 10mm or the size is greater than 50*50mm, a chippper is needed to chip these materials into smaller pieces.


(c)Grinding Process

 The hammer mill is used to further crush these small pieces into particles of less than 3mm in diameter.



(d)Drying Process

 After raw materials are crushed a dryer is needed since most raw wood materials havea moisture content of about 50%. However, the optimal moisture content for pelletiztionis 13%-15%. Therefore a rotary dryer is included in the pellet plant to reduce the moisture content. After crushing and drying you can begin making wood pellets.


(e)Pelletizing Process

After crushing and drying the raw material properly it is then ready for the pellet mill. The pelletizing machine or 

press is the key piece of machinery in the pellet plant. It should be mentioned that impurities in the raw materials 

like metal or stone,may damage the die and rollers of pellet making machine.



(f)Cooling Process

Usually after pelletizing, the temperature of pellets is between 60-80 degrees and the moisture content is close to 15%. For storage purpose, a cooler must be used to reduce their surface temperature and moisture content.


(g)Packing Process

Finally is the packing process. In order to protect the wood pellets becoming getting 

damp and to increase storability, proper packing is necessary.